Cable And Pulley Routing - Bowflex Xtreme 2 SE Assembly Manual

step 17 Cable and Pulley Routing – Prepare Cables to be installed to the Lat Pulley Housing
Locate the following items on the Lat Pulley Housing assembly:
• (2) Pulleys – already installed, labeled as item 2 in figure
• 3/8" X 4 1/2" Hex Head Bolt – installed
• 3/8" Washer – already installed
note:
Connecting the Cables is much easier with a second persn assisting you .
17-1
Remove
the 4 1/2" Bolt and Washer from the back of the Lat Pulley Housing, and set safely aside for Step 18.
17-2
The 2 Pulleys will slide down and out of the housing without the hex bolt holding them in place.
Unwrap the Right Pulley Cable on the Right Frame Rail. Thread the cable beneath and then over one Lat Pulley (2),
following the arrows shown in Figure 20 and holding the cable tightly where indicated .
17-3
Repeat for the Left Pulley Cable (on the Left Frame Rail), without loosening your grip on the Right Pulley Cable.
16
Bowflex Xtreme 2 SE Assembly Manual
®
Assembly Guide
2
1
2
1