Table of Contents
Advertisement
Maintenance and Troubleshooting
Problem
Problem
Number
34
I pressed the shaft engage
push button and the shaft did
not engage.
35
The machine was running,
but stopped abruptly.
36
The machine was running,
but then the rolls went up
and the machine stopped
37
Nothing seems to work.
38
Slitter is not cutting.
39
Paper rips easily at the point
it is pulled off.
4-12
ORCA-IV Image Transfer Laminator Operation Manual
Possible Cause
a. Are the guard doors closed?
b. Is the machine reset?
c. Are the e-stop buttons pressed
and the kick cables reset?
a. Has the machine blown a fuse?
b. Did you activate the kick cable?
a. Was the e-stop pressed?
b. Did you activate the kick cable?
a. Is the machine reset?
a. Is the blade adjusted properly?
b. Is the blade dull or damaged?
c. Is the bushing that mounts the
blade worn out?
a. Is the slitter tube enlarged?
Corrective Action
a. Close the doors.
b. Reset the machine. See "Machine
Reset Procedure" on page 3-3.
c. See problem 12.
a. Check fuses on the back of the
machine.
b. Reset the kick cable.
a. Reset the e-stop and reset the
machine. See "Machine Reset
Procedure" on page 3-3.
b. Reset the kick cable and reset the
machine. See "Machine Reset
Procedure" on page 3-3.
a. Reset the machine. See "Machine
Reset Procedure" on page 3-3.
a. Check blade adjustment. "Setting
the Slitter" on page 3-12
b. Replace blade.
c. Replace the bushing.
a. The plastic slitter tube can
become enlarged from many cuts
in a close area. This causes the
edge of the paper to go around a
larger diameter at the slitter sta-
tion and causes small tears in the
paper's edges which can lead to
the paper starting to tear all the
way across at the rear idler. The
solution is to sand/file down the
frequently used raised areas on
the slitter's plastic tube.
© GBC Pro-Tech 1998 October
Advertisement
Table of Contents
