Care And Cleaning - Zanussi ZSF2450 User Manual

Product manaul
Hide thumbs Also See for ZSF2450:
Table of Contents

Advertisement

– The countdown of the delay start starts.
– The countdown of the delay start decreases with
steps of 1 hour.
– When the countdown is completed, the washing
programme starts automatically.
Do not open the door during the countdown to pre-
vent interruption of the countdown. When you close
the door again, the countdown continues from the point
of interruption.
Cancelling a delay start:
1. Press and hold function buttons B and C until all the
programme lights come on.
– When you cancel a delay start, you also cancel the
washing programme.
2. Set a new washing programme.
You can select the washing programme and delay
start also with the door closed. When you press a
programme button you have only 3 seconds to select a
different washing programme or a delay start. After these
3 seconds, the selected programme starts automatically.
End of the washing programme
Switch off the appliance in these conditions:

Care and cleaning

Warning! Switch the appliance off before you clean
the filters.
Cleaning the filters
Important! Do not use the appliance without the filters.
Make sure that the installation of the filters is correct.
Incorrect installation will cause unsatisfactory washing
results and damage to the appliance.
• The appliance stops automatically.
• The display shows 0.
• The end-of-programme indicator light comes on.
1. Press the on/off button.
2. Open the door.
3. For better drying results, keep the door ajar for some
minutes before you remove the dishes.
Let the dishes cool down before you remove them from
the appliance. Hot dishes are easily damaged.
Standby mode
If you do not switch off the appliance at the end of the
washing programme, the appliance automatically goes
into standby mode. The standby mode decreases energy
consumption.
Three minutes after the end of the programme, all indi-
cator lights go off and the digital display shows one hor-
izontal bar.
Press one of the buttons (not the on/off button), to go back
to end-of-programme mode.
1
A
B
2
Remove the filters A and B
from the bottom of the ap-
pliance.
11

Advertisement

Table of Contents
loading

Table of Contents