GBC 930-028 Operating And Maintenance Manual page 15

F-60+ Operation and Maintenance Manual
4. Carefully remove the accessory pack from the skid.
The accessory pack should contain:
1 Slitting knife
1 Manual
1 Set, spare fuses
1 Roll of masking tape
1 100% cotton terry cloth
4 Leveling pads
5. Locate the foot switch so as to prevent the foot
switch wire from being damaged during removal of
the machine from the skid.
Do not attempt to move the laminator across
anything other than a flat, level surface without
trained and qualified riggers. You can be crushed
or seriously injured. Steps 6 through 11 should be
completed by LICENSED RIGGERS ONLY.
The F-60+ Laminator is a large and heavy piece
of equipment. It is necessary to employ
LICENSED RIGGERS ONLY to move the
machine.
GBC Pro-Tech bears no responsibility for
personal injury or damage due to moving the
laminator improperly.
6. The machine is supported above the skid by resting
on a support saddle under each end of the machine.
Remove the three long two by fours that attach to
the support saddles.
7. On one side of the machine, remove the lag bolts
holding the support saddle to the skid.
8. Using two of the two by fours as levers, carefully
lift the end of the machine enough to allow the sad-
dle to be removed from the skid and the machine to
rest on its wheels.
9. Repeat Steps 7 and 8 for the other end of the
machine.
© GBC Pro-Tech 1999 April
WARNING
10. The ramps included with the laminator can be
secured to the edge of the crate bottom using the
screws left over from the crate disassembly (see
Figure 2-3).
11. Have the machine moved off the skid and placed
on the floor by licensed riggers.
Roll the machine off by securing included ramps to
the edge of the crate bottom using the screws left
over from the crate disassembly (See Figure 2-3).
Lift the machine off by applying fork lift truck
blades to the two bottom tie bars between the cabi-
nets. The fork lift blades must be located at the lift
label locations on the tie bars (see Figure 2-5).
IN G
R N
W A G
UN
HT E
AC GA RD
E EN
MIS
IN G
R N
W A G
UN
HT
AC RD E
GA
E EN
MIS
Fork Lift Label
Locations
Figure 2-5: Fork Lift Blade Locations
12. Remove any plastic strapping and packing paper
taped to the s.
roll
Do not use a knife or other sharp instrument
during installation or while servicing the
laminator. You can cause irreparable damage to
the rolls.
13. Remove all packing materials to a safe distance
from the laminator.
Installation
CAUTION
2-5