Table of Contents
Advertisement
5
6
7
8
9
10
58
CHAPTER 5: Upgrading Your Computer
Remove the hard drive by sliding it out of the drive bay.
Slide the new drive into the drive bay, then secure it in
the drive bay by sliding the drive release latch back.
If you are replacing a drive, reconnect the drive cables
using your notes from Step 4. If you are installing a new
drive, follow the manufacturer's instructions for
connecting it to the system board.
You can also refer to the following figure for SATA port
assignments:
Replace the side panel by following the instructions in
"Replacing the side panel" on page
Reconnect all external cables and the power cord.
Turn on your computer.
SATA 6 port
SATA 5 port
SATA 4 port
SATA 3 port
SATA 1 port
SATA 2 port
50.
Advertisement
Table of Contents
