Disarming; High Security Disarm - Viper 3305V Owner's Manual

Disarming

To disarm the system, press
ing lights will flash twice. If the power locks are connected to the sys-
tem, the doors will unlock. If the siren chirps either four or five times
when disarming, refer to the Diagnostics section of this guide. This is
called Tamper Alert.
The remote sounds 2 beeps and the unlock icon
when the system is disarmed.
When disarming after the system has been triggered, the remote
sends a diagnostic notification, as described below:
If a sensor triggered the system the remote emits 4 quick beeps,
and the LCD screen flashes the zone indicator to display which
sensor tripped the alarm.
If a switch (Zone 1, 3 or 5) triggered the system, the remote emits
4 quick beeps, and the LCD screen flashes the zone indicator to
display which switch tripped the alarm.
If the system was triggered enough times that NPC (See Nui-
sance Prevention Circuitry) is active, the remote emit 5 beeps.

High Security Disarm

High Security Disarm makes it possible to silence and reset the system
when it is triggering, without disarming. If the system is triggered, and
the siren sounds for longer than six seconds, pressing the
will stop the trigger and return the system to an armed state. The sys-
tem does not disarm, but rather reset. This prevents you from disabling
the system should you want to disarm without visually checking the
vehicle. Pressing the
disarm the system. Pressing the
of the triggered sequence disarms the system immediately. The six sec-
© 2012 Directed. All rights reserved.
. You will hear two chirps, and the park-
button again after resetting the system, will
button during the first six seconds
flashes 5 times,
button
15