Lan Settings - ZyXEL Communications NBG4115 User Manual

Table 26 Screens Summary
LINK
System
Logs
Tools
Sys OP Mode
Language

5.4 LAN Settings

Use this section to configure your LAN settings while in AP Mode.
Click Network > LAN to see the screen below.
Note: If you change the IP address of the NBG4115 in the screen below, you will need to
log into the NBG4115 again using the new IP address.
Figure 33 Network > LAN > IP
The table below describes the labels in the screen.
Table 27 Network > LAN > IP
LABEL
Get from DHCP
Server
User Defined
LAN IP
IP Address
NBG4115 User's Guide
TAB FUNCTION
General Use this screen to view and change administrative settings such
as system and domain names, password and inactivity timer.
Time Setting Use this screen to change your NBG4115's time and date.
View Log Use this screen to view the logs for the categories that you
selected.
Firmware Use this screen to upload firmware to your NBG4115.
Configuration Use this screen to backup and restore the configuration or reset
the factory defaults to your NBG4115.
Restart This screen allows you to reboot the NBG4115 without turning the
power off.
General This screen allows you to select whether your device acts as a
Router or a Access Point.
This screen allows you to select the language you prefer.
DESCRIPTION
Select this to let the DHCP server in the gateway assign the NBG4115 IP address.
Select this to give the NBG4115 a static IP address.
Type the IP address in dotted decimal notatiion. The default setting is 192.168.1.2.
If you change the IP address you will have to log in again with the new IP address.
Chapter 5 AP Mode
59