3‐5‐1‐4 AP Bridge—Point to Multi‐Point
"AP Bridge—Point to Multi‐Point" mode connects this router to up to 4 other routers
and allows the computers connected to the LAN ports of every router to communicate with
each other.
Please note that when you select this mode, this broadband router will act as a wireless
bridge only. It will not accept other wireless clients. If you wish to use this function with a
wireless access point that supports WDS, please select "AP Bridge—WDS" mode.
Item Name
Band
Channel Number
MAC Address 1 to 4
Wireless Module
Description
Select from one of the following options:
5GHz (A): Allows 802.11a wireless network clients to
connect to this router.
5GHz (N): Allows 802.11n wireless network clients to
connect to this router (maximum transfer rate
300Mbps).
5GHz (A+N): Allows 802.11a and 802.11n wireless
network clients to connect to this router
(recommended).
Select a channel from the dropdown menu. All access
points must use the same channel (1 to 140).
Input the MAC addresses of the wireless access points
with which you wish to connect.
Select "Enable" to turn on the 5GHz wireless signal
and select "Disable" to turn it off.
93