Edimax 3G-6200nL V2 User Manual page 64

ESSID
Channel Number
Associated Clients
Wireless Module
Click "Apply" to save the changes, or click "Cancel" to discard the changes. After you
have clicked "Apply", you will see the following message:
Click "Apply" to save the changes and restart the broadband router. It takes about 60
seconds for the broadband router to restart. Click "Continue" to configure other settings.
2.4GHz (G): Allows 802.11g wireless network clients
to connect to this router (maximum transfer rate
54Mbps).
2.4GHz (B+G+N): Allows 802.11b, 802.11g, and
802.11n wireless clients to connect to this router
(recommended).
This is the name of your router. You can type any
alphanumerical character here (maximum 32
characters).
Select a channel from the dropdown menu. You can
select the channel of your preference (1 to 13).
Click "Show Active Clients" for the list of all
connected wireless clients. Click "Refresh" in the
new window to renew the list, and click "Close" to
close the window.
Note: If you have a pop-up blocker installed, you
may have to disable it, or set it to allow the pop-up
window to show up.
Select "Enable" to turn on the 2.4GHz wireless
signal and select "Disable" to turn it off.
63