Clone Programmer Troubleshooting - LG Pro Centric 37LT777H Commercial Mode Setup Manual

Troubleshooting (Cont.)

Clone Programmer Troubleshooting

Caution: If the TV is in
LodgeNet PPV Mode
Mode via EBL (check with the
site administrator if you are
not certain), do not connect
a clone programmer to the
GAME CONTROL/MPI port,
as this will damage the clone
programmer.
Clone Programmer
Symptom
Clone copies setup in less
than 30 seconds.
Remote does not operate
clone programmer.
Clone menu does not dis-
play on TV screen, TLL-
1100A shows error mes-
sage, or LT2002 LED does
not blink.
Clone menu hard to read.
No time set.
Clone not working.
Clone scans channels
more than once.
Master and Target TVs
Symptom
Cloning did not work.
(LT2002 only) Clone time
disappeared.
New setup not present.
•
After cloning operations are complete, unplug the TLL-1100A/LT2002 from the TV.
•
If the TV does not display a picture (blank screen) after a few seconds, just change channels.
82
Reset Clone Programmer After Static Shock
or FTG
After replacing exhausted batteries (LT2002 only), or if the clone programmer
behaves strangely after a static shock:
• TLL-1100A: Turn the TLL-1100A OFF and then ON.
• LT2002: Use a paper clip or similar instrument inserted through the small hole
marked RESET to activate the internal reset switch and restore normal operation.
After a reset, check the real-time clock setting. It may be necessary to set the
clone programmer clock from a TV containing the correct time.
Note: Both the Master and Target TVs must be in Pass-through Mode for cloning
purposes. See also IMPORTANT CLONING INFORMATION on page 36.
Possible Cause(s)
Not enough time to copy entire
TV setup.
Wrong Installer Remote.
MPI cable not connected.
TV not turned ON.
(LT2002 only) Weak batteries.
(TLL-1100A only) No charge.
Weak signal.
Time not available.
Clone programmer problem.
Clone should only scan channels
once.
Possible Cause(s)
Procedure interrupted.
Different TV models.
Step(s) omitted or not performed.
Batteries were removed.
Target TV not reset.
Possible Solution(s)
TLL-1100A: Turn the TLL-1100A OFF and then ON.
LT2002: Press RESET on clone programmer.
Then redo Learn/Teach. (Learning usually takes about 90 seconds;
Teaching usually takes 3 to 4 minutes.)
Only use an LG Installer Remote to operate clone programmer
with TV.
Connect MPI cable properly, and ensure good connection.
TV must be turned ON for clone programmer to work.
Install four (4) fresh AA high-quality alkaline batteries.
Ensure the TLL-1100A is fully charged or connected to AC power.
Connect TV to a reliable analog channel signal source.
Set time on a TV, and copy time to clone programmer.
•
Try a different clone programmer.
•
Reset the clone programmer.
Ensure TV is set up correctly, and try cloning again.
Possible Solution(s)
Wait until procedure complete message is displayed.
Cloning is only possible with identical model TVs.
Refer to the applicable cloning procedure(s), and make sure all
tasks were performed.
Batteries must remain installed to retain time settings.
Disconnect Target TV from AC power for 15 seconds.
206-4234