Teaching Ftg Configuration To A Tv - LG Pro Centric 37LT777H Commercial Mode Setup Manual

Teaching FTG Configuration to a TV

This section describes how to "Teach" an FTG Configuration file from a USB memory device to a TV
using the USB Download Menu. Ensure you have completed the procedure on the previous page to
create the FTG Configuration file before proceeding with the steps below.
Before You Begin
• If the TV EBL is already in FTG Mode, you cannot use this procedure to make changes to the
FTG Channel Map and FTG Installer Menu settings. You must use a direct PC-to-TV connection
as described in Reference section, "FTG Mode via EBL (Local Configuration)," or an FMA head
end device to reconfigure the EBL.
• If the preceding condition applies, but you wish to switch the TV to FTG mode via CPU, refer
to Reference section, "Restoring Factory Defaults on the TV(s)," for further information before
proceeding.
• If the EZ-Manager Wizard appears on the screen when you turn ON the TV, you can complete the
Teaching process via the wizard (see "USB Configuration" on pages 17 to 18).
• You may also use the LG Smart Install utility to complete this process. See "LG Smart Install Utility"
on pages 19 to 20 for further information.
• If the TV is currently in Pass-through Mode and you intend to use the TV Zoning feature, make
sure to assign a TV Zone # as described in Reference section, "Using the TV Zoning Feature,"
BEFORE continuing with the procedure below.
Teach FTG Configuration
1. Turn ON the Target LT777H TV, and then insert the USB memory device that
contains the FTG Configuration file into the TV's USB IN port.
2. Press MENU SETTINGS on the Installer Remote to display the TV setup
menus (TV is in Pass-through Mode) or the Function Menu (TV is already in
FTG Mode).
3. Use the arrow navigation keys to select/highlight either the Option menu icon
from the TV setup menus or the Lock menu icon from the Function Menu.
Then, press the number "7" key a total of seven times to display the USB
Download Menu.
4. Use the Up/Down arrow keys to select Teach To TV (TLX), and then press OK.
5. Use the Up/Down arrow keys to select the FTG Configuration file you want to
install, and then press OK.
Teaching status will be shown on a progress bar in a new window.
Do NOT remove the USB device until Teaching is complete. When the Teaching
process is complete, the TV will briefly display a "Teaching Completed" window
and then exit the USB Download Menu.
6. Remove the USB memory device from the Target TV, and verify that the FTG
Configuration is resident on the Target TV.
The Target TV CPU is now in FTG Mode (if it was previously in Pass-through Mode).
Note: After the Teaching process is complete, the TV tunes according to the Start
Channel setting in the Installer Menu. If a Start Channel is specified, the TV will
tune to that channel; otherwise, the TV will tune to the lowest logical channel in the
FTG Channel Map.
206-4234
FTG Mode via CPU (Cont.)
USB Download Menu
Upgrade TV Software
Upgrade PTC Software
Diagnostics
Teach To TV (TLL)
Teach To TV (TLX)
Previous
Note: The Diagnostics option in
this menu is for service use only.
Teach To TV (TLX)
xxLT777H-UA00005.TLX
Previous
Teach To TV
UPDATING...
Do not unplug!
OK
OK
50%
49