Programming And Reprogramming Search Banks - AOR AR2700 Operating Manual

The flashing legend "BANK" appears in the
top left corner of the LCD with the current
bank number shown directly underneath.
The UPPER and LOWER program search
bank limits will alternate on the LCD along
with the legends "HI" and "Lo".
To view the limits of a different program
search banks use the UP / DOWN keys or
[DIAL] to make the selection.
To return to program search mode press [ENT] otherwise the receiver will
return to program search mode automatically after about 30 seconds.
Alternatively should you wish to return to a different program search bank,
press a numeric key corresponding to the search bank required (no [ENT] is
required).
11-5 Programming and reprogramming PROGRAM SEARCH BANKS
You may wish to specify your own frequency limits or modes for program
search banks, you may also reprogramme any which may be already
pre-programmed. There are 10 program search banks in total identified as
banks 0, 1, 2, 3, 4, 5, 6, 7, 8 & 9.
Example of reprogramming a search bank - "5"
For example, to reprogramme the data contents of search bank "5" to the
following parameters:
Low frequency
High frequency
Receive mode
Step size
Attenuator
Starting to reprogramme
Use the key sequence [2ndF] [SRCH] to initiate the process or programming a
search bank. The flashing legend "SEARCH" indicates that reprogramming is
in process.
Selecting the bank
Use the UP / DOWN keys, [DIAL] or
numeric keypad to select the desired
program search bank for reprogramming.
Press [ENT] to accept the selected bank.
In this example press [5] [ENT]
Selecting receive mode
The current upper and lower frequencies will alternate on the LCD along with
step size and receive mode, this helps acknowledge that the correct bank has
433.000 MHz
433.600 MHz
FM
25 kHz steps
OFF