Memory Transfer To Vfo - AOR AR2700 Operating Manual

process. Alternatively, the UP /
DOWN key may take the place of the
second [SCAN] key press.
Secondly
From "MEMORY RECALL" mode:
Press [SCAN] once holding the key for more than 1.5 seconds to
initiate the scan process. Alternatively, the UP / DOWN key may take the
place of the [SCAN] key press.
To reverse the direction of SCAN press either the [UP] or [DOWN] key or
rotate the [DIAL].
The legend "SCAN" is displayed on the top row of the LCD to indicate that the
SCAN process has been initiated.
When SCAN has been selected, ALL MEMORY CHANNELS WHICH
CONTAIN DATA in the memory will be SCANNED irrespective of mode and
frequency. ANY BLANK (empty) MEMORY CHANNELS which contain no data
will be ignored (skipped).
The memory bank identifier (such as "0") will be displayed on the left of the
LCD with channel numbers changing.
When an "active" channel has been
located (busy so the squelch opens) the
scan process will temporarily pause on the
active channel and the memory location
(such as "123") will be displayed on the
LCD.
Finally when the channel becomes clear
again (the signal disappears) and squelch
closes, the receiver will wait for an
additional two seconds (default delay) to
allow for a reply on the channel before resuming the scanning process.
To force the receiver to pause on a memory channel for about 30 seconds,
press [2ndF] [SCAN].
To cancel the SCAN process and return to the VFO's previous frequency
without transferring the contents of the memory channel press [MANU].

9-3 Memory transfer to VFO

When stopped on an active channel or when using memory recall, press
[SCAN] to transfer the memory data (frequency, mode, step & attenuator) to
the VFO and the receiver will change to MANUAL MODE where you may tune