Problems When Projection Starts; Other Problems - Epson EMP-X3 User Manual

Problems Solving
Nothing appears on the external monitor
Check
Are images from a port other than the
Computer port being projected? (EMP-X3
only)
Are images from a port other than the
Computer1 port being projected? (EMP-
82/62 only)

Problems when projection starts

Power does not turn on
Check
Have you pressed the [Power] button?
Are all of the indicators switched off?
Do the indicators turn off and on when the
power cable is touched?

Other problems

No sound can be heard or the sound is faint
Check
Is the audio source connected correctly?
Has the volume been adjusted to the
minimum setting?
Is A/V Mute mode active?
The only images that can be displayed on an external monitor are those from the Computer port. You
cannot output video equipment images to an external monitor.
The only images that can be displayed on an external monitor are those from the Computer1 port. You
cannot output video equipment images to an external monitor.
Press the [Power] button to turn the power on.
The power cable is not connected correctly or power is not being supplied. Connect the power cable to
the projector correctly.
sp.iii
Alternatively, check the circuit breaker to see if power is being supplied.
There is probably a poor contact in the power cable, or the power cable may be defective. Reinsert the
power cable. If this does not solve the problem, stop using the projector, disconnect the power cable from
the wall outlet and contact the nearest address provided in the "International Warranty Conditions"
section of the Safety Instructions/World-Wide Warranty Terms booklet.
Check that the cable is connected to the Audio port.
Adjust the volume so that sound can be heard.
Press the [A/V Mute] button on the remote control to cancel the A/V mute function.
Remedy
sp.66
sp.66
Remedy
Remedy
sp.17
53
sp.20