D Direct Code Entry - Icom IC-F51 Instruction Manual

4
BIIS OPERATION

D Direct code entry

q While in the standby condition, push [TX Code Enter] to enter
the TX code edit mode.
• Editable code digit blinks.
w Push [TX Code Enter] to select the desired digit to be edited.
• Editable digit differs according to the setting.
e Set the desired digit using [
Code CH Down].
r Push [TX Code Enter] to set the digit. The editable digit will
move to the right automatically.
t Repeat e and r to input all allowable digits.
y Push [P0] (Call) or [PTT]* to call.
* PTT call can be made only when PTT call capability is permitted.
NOTE: When no answer back is received, the transceiver re-
peats the call 3 times (default) automatically, and
displayed during each call. However, an error beep sounds
and
after the calls.
u Push [PTT] to transmit; release to receive.
i Push [P3] (Moni(Audi)) to send the "Clear down" signal.
For your information
When the "UpDate" setting for the call code is enabled, the set
code is overwritten into the call code memory.
25
is displayed when no answer back is received
" "
]/[ ]/[TX Code CH Up]/[TX
is
" "