Power Outage - GE EGR3000 Owner's Manual & Installation Instructions

Usingthe oven.
Toavoid possible bums, place the shelves in the desired position before you turn the oven on.
Before you begin...
The shelves have stoic-locks, so that when
I)laced correctly on tile shelf supports
(A through E), they will stop befiwe
confing completely out, and will not tilt,
_,\]/en
placing
and removing cookware,
pull tile shelf out to tile bum l) on tile
shelf SUl)po_t.
Toremove a shelf, pull it toward you, tilt tile
ti'ont end up and pull it out.
TOreplace, i)lace the end ot the shelf
(stopqocks) on the sui)port, tilt up the
front and push the shelf in.
NOTE: Theshelf is not designed to slide out at the
specb/ low shelf (R)position.
The oven has 5 shelf positions.
It also has a special low shelf
position (R)for extra large items,
such as a large turkey.
Plastic items on the cooktop may
melt if left too close to the venL
Vent appearance and location var_
Oven Vent
_ur (wen is vented through ducts at tile
rear ot the range. Do not block these ducts
when cooking in tile oven--it is important
that tile flow of hot air fl'om tile oven
and fl'esh air to tile oven burner be
tminterrui)ted. Avoid touching tile vent
ol)enings or nearby SUltaces during oven
or
broiler ope_wtion--they may become hot.
::Ji:: Handles ofpotsandpanson thecoo/cop may
become hot if left toodose to theven£
_: Donot leave plast/e or flammable items on the
coo/Cop--they may melt or ignite if left too close
to the venL
::Ji:: Donot/eavec/osed containers on thecoo/Cop.
The pressure lb c/osed containers mayincrease,
whichmaycause themto burst.
_: Metalitemswi//become very hot if theyare left
on thecoo/Cop, andcouldcause burns.
Power Outage
CAUTION: Donotmakeany
attempt to operate the electric/_?nitionoven
duringan electricalpower failure.
Tile oven or broiler
cannot be lit (huing
a power fifilure. Gas will not flow unless
the glow bar is hot.
If the oven is in use when a power fifilure
OCClli_ tile
oven b/lI'neI"
shtlts off and
cannot be re-lit until power is restored. This
is because tile flow of gas is automatically
stopped and will not resume when power
is restored until the glow bar has reached
operating temperature.
Oven Light
Touch tile
OVEN
LIGHTpad
on tile upI)er
control panel to turn tile light
on or off'.
12