Fujitsu Stylistic Q552 User Manual page 49

Have a charged battery ready to install.
1
Perform one of the following two steps:
2
• Click the Fujitsu Battery Swap Utility icon on the desktop. Follow the instructions that appear to put the system
into Hibernate mode. (Please note that the system has not yet entered Hibernation until the Power indicator
is no longer lit.) Using this procedure saves your data and the system powers down. It is then safe to swap the
batteries.
• Save your data, then power down the system. It is then safe to swap the batteries.
Note that the battery latch on the left is spring loaded, while the latch on the right is not. Unlock the battery by
3
first pushing the right latch backwards, then pushing and holding the left latch (Figure 17). While holding the left
latch, lift the battery out at the lift point (Figure 18).
To install a battery, first verify that the right latch is pushed back. While pushing the left latch back and holding
4
it, insert a new battery into the bay (Figures 19 and 20). Lock the battery in place by sliding the right latch
forward.
Plug in the AC adapter and turn the power on.
5
Figure 17. Unlocking the Battery
Lift Point
48 - Lithium Polymer Battery
Figure 18. Removing the Battery