Operating The Dryer; Cycle Setting Buttons; Cycle Option Buttons - LG Tromm DLEX8377NM User's Manual & Installation Instructions

HOWTO USE HOW TO USE
OPERATING THE DRYER
Once you have loaded the dryer:
O Press the ON/OFF button to turn on the
dryer. The lights around the cycle
selector knob will illuminate.
O Turn the selector knob to the desired
cycle
cycle. The display will show
the preset Dry Level,
Temperature, Time, and
Option settings for that cycle.
_1 If you would like to change the settings
for that cycle, press the option button(s)
to display additional settings for that option.
Press the button again to cycle through
the settings until the desired setting is
highlighted.
NOTE: To protect your garments, not every
dry level, temperature, or option is available
with every cycle.
_I Select any additional cycle options, such
as REDUCE STATIC, EASY
IRON, CUSTOM PROGRAM,
WRINKLE CARE, (*RACK DRY),
and ANTI BACTERIAL, or
(*DAMP DRY BEEP), by
pressing the button for
that option.
O Press the START/PAUSE button to begin the
cycle. The display will change,
and the dryer will display the
estimated (SENSOR DRY) or set
time (MANUAL DRY) remaining
and start tumbling. To pause the cycle at any
time, open the dryer door or press PAUSE.
To resume the cycle where it was stopped,
press START/PAUSE again.
NOTE: If the dryer has been stopped for
more than 8 minutes, the dryer will turn
off automatically.
O
When the load is finished, the beeper (if set)
will sound. If you have set the WRINKLE
CARE option, the dryer will tumble the load
periodically for up to 3 hours.
To prevent wrinkling, remove items from the
dryer immediately after the end of the cycle.
O
Always clean the lint filter after every cycle.
To clean, pull the lint filter straight up and
roll any lint off the filter with your fingers.
Do not rinse or wash the filter to remove lint.
Push the lint filter firmly back into place.
CYCLE SETTING BUTTONS
SENSOR DRY cycles have preset settings
that are selected automatically and cannot be
changed. MANUAL DRY cycles have default
settings, but you may also customize the settings
using the cycle setting buttons. Press the button
for that option to view and select other settings.
DRY LEVEL
Selects the level of dryness for the
cycle. Press the DRY LEVEL button
repeatedly to scroll through available
settings.
• This option is only available with SENSOR DRY
cycles.
• The dryer will automatically adjust the cycle
time. Selecting VERY DRY or MORE DRY will
increase the cycle time, while LESS DRY or
DAMP DRY will decrease the cycle time.
• Use a LESS DRY or DAMP DRY setting for
items that you wish to iron.
CYCLE OPTION BUTTONS
Your dryer features several additional cycle
options to customize cycles to meet your
individual needs. Certain option buttons also
feature a special function (see the following page
for details) that can be activated by pressing and
holding that option button for 3 seconds.
TOAdd Cycle Options to a Cycle:
_1 Turn on the dryer and turn the cycle selector
knob to select the desired cycle.
O Use the buttons to the
cycle setting adjust
settings for that cycle.
O Press the cycle option button(s) for the
option you would like to add. A confirmation
message will be shown in the display.
O Press the START/PAUSE button to start the
cycle. The dryer will start automatically.
NOTE: To protect your garments, not every
dryness level, temperature, or option is available
with every cycle. See the Cycle Guide for details.
TEMP. CONTROL
Adjusts the temperature setting from
ULTRA LOW to HIGH. This allows
precise care of your fabrics
and garments. Press the TEMP.
CONTROL button repeatedly to scroll through
available settings.
TIME DRY
Allows you to manually select the drying
time, from 20 to 60 minutes, in 10-
minute increments. Use this for small
loads or to remove wrinkles. Use the
MORE TIME/LESS TIME buttons to add or reduce
the drying time in 1-minute increments.
BEEPER
g Adjusts the volume of the end-of-cycle
beeper, or turns off the beeper.
WRINKLE CARE
Selecting this option will tumble
[ '
the load periodically for up to 3
hours after the selected cycle,
or until the door is opened. This is helpful in
preventing wrinkles when you are unable to
immediately remove items from the dryer.
ANTI BACTERIA L
This option will add a high heat
setting to reduce bacteria. It can
only be used with the HEAVY
DUTY, CO-M-ON/TOWELS, and NORMAL cycles.
NOTE: Do not use this cycle with delicate fabrics.