Adapting To Different Types Of Gas; Table Of Characteristics - Indesit IS60D1 S Operating Instructions Manual

Disposing of the appliance
When disposing of the appliance please remove the
plug by cutting the mains cable as close as
possible to the plug body and dispose of it as
described above.
Checking the connection for leaks
When the installation process is complete, check
the hose fittings for leaks using a soapy solution.
Never use a flame.

Adapting to different types of gas

It is possible to adapt the appliance to a type of gas
other than the default type (this is indicated on the
rating label on the cover).
Adapting the hob
Replacing the nozzles for the hob burners:
1. Remove the hob grids and
slide the burners off their
seats.
2. Unscrew the nozzles using
a 7 mm socket spanner ( see
figure ), and replace them with
nozzles suited to the new type
of gas ( see Burner and nozzle
specifications table ).
3. Replace all the components by following the
above instructions in reverse.
Adjusting the hob burners' minimum setting:
1. Turn the tap to the minimum position.
2. Remove the knob and adjust the regulatory
screw, which is positioned inside or next to the tap
pin, until the flame is small but steady.
! If the appliance is connected to a liquid gas
supply, the regulatory screw must be fastened as
tightly as possible.
3. While the burner is alight, quickly change the position
of the knob from minimum to maximum and vice versa
several times, checking that the flame is not
extinguished.
! The hob burners do not require primary air adjustment.
! After adjusting the appliance so it may be used
with a different type of gas, replace the old rating
label with a new one that corresponds to the new
type of gas (these labels are available from
Authorised Technical Assistance Centres).
! Should the gas pressure used be different (or vary
slightly) from the recommended pressure, a suitable
pressure regulator must be fitted to the inlet hose in
accordance with current national regulations relating
to "regulators for channelled gas".
TABLE OF CHARACTERISTSICS
width 43,5 cm
Dimensions
height 32 cm
depth 40 cm
Volume
57 l
Useful
width 46 cm
measurements
height 8,5 cm
relating to the oven
depth 42 cm
compartment
may be adapted for use with any type
of gas shown on the data plate, which
Burners
is located inside the flap or, after the
oven com partment has been opened,
on the left-hand wall inside the oven.
Voltage and
see data plate
frequency
Directive 2002/40/EC on the label of
electric ovens.
Standard EN 50304
Energy consumption for Forced
convection heating mode:
ENERGY LABEL
Fan assisted
Declared energy consumption for
Natural convection Class heating
mode:
This appliance conform s to the
following European Economic
Community directives: 2006/95/EC
dated 12/12/06 (Low Voltage) and
subsequent amendments –
2004/108/EC dated 15/12/04
(Electromagnetic Compatibility) and
subsequent amendments - 93/68/EEC
dated 22/07/93 and subsequent
amendments.
2002/96/EC
2009/142/EC dated 30/11/09 (Gas)
1275/2008 (Stand-by/ Off mode)
GB
Convection
5