GE AJCM08ACEQ1 Owner's Manual & Installation Instructions page 7

GEAppliances.com
COOL MODE
Remote Control
1. Press COOLpad.
2. Press LOW ar HIGHpads to set desired fan speed.
3.Press the INCREASE + / DECREASE - padsto setthe
desiredtemperature60°Fto 85°Fin l°F increments.
ControlPanel
1.Press the MODE pad untilthe COOLindicatorlightis lit.
2.Press the FANpad until HIGHar LOWindicatorlight
islit for desiredfan speed.
3.Press the INCREASE + / DECREASE - padsto setthe
desiredtemperature60°Fto 85°Fin :].°F increments.
A thermostatisusedto maintainthe roomtemperature.
Thecampressor w ill cyclean and affta keepthe room
at the set levelof camfart.Setthe thermostatat a lower
numberand the indaorair will becamecaoler.
Setthethermostatat a highernumberand the indoorair
will becomewarmer.
NOTE: I f the air conditioner i s off and isthenturnedon
whileset to COOL, it will takeapproximately 3 minutes
for thecompressor t o startand coolingto begin.
CoolingDescriptions
For Normal Cooling-Selectthe COOLmodeand HIGH
fan with a middlesettemperature.
For MaximumCooling-SelecttheCOOLmode
and HIGHfan with a lowerset temperature.
For Quieterand Nighttime Cooling-Selectthe COOL
modeand LOWfanwith a middleset temperature.
NOTE: T herewill be a 3-minute delaybetweensetting
changessuchas COOL to OFF and back to COOL.
HEAT MODE
RemoteControl
1.Press HEAT pad.
2.Press LOWor HIGHpadsto set desiredfan speed.
3.Press the INCREASE + / DECREASE - padsto set the
desiredtemperature60°Fto 85°Fin :].°F increments.
Control Panel
1.Press the MODE pad untilthe HEAT indicatorlightis lit.
2.Press the FANpad untilHIGHor LOWindicatorlight
is litfor desiredfan speed.
3.Press the INCREASE + / DECREASE - padsto set the
desiredtemperature60°Fto 85°Fin :].°F increments.
A thermostatis usedto maintainthe roomtemperature.
Theheaterwill cyclean and off to keepthe room
at the set levelof camfart.Setthethermostatat a higher
numberandthe indaor air willbecamewarmer.
Setthe thermostatat a lowernumberand the indoorair
will becomecooler.
NOTE: If the air conditioner i s off and isthenturnedon
whileset to HEAT, it will takeappraximately 1 minute
forthe heaterto startand heatingto begin.
HeatingDescriptions
ForNormal Heating-Select the Heat modeand HIGH
fan with a middleset temperature.
ForMaximumHeating-Select the HEAT mode
and HIGHfan with a highersettemperature.
ForQuieterand Nighttime Heating-Select the HEAT
modeand LOWfan with a middlesettemperature.
FAN
Usethe FANto provideair circulationand filtering
without coolingor heating. S incefan onlysettingsda nat
providecoolingar heating,a temperaturesettingwill nat
be displayed.
RemoteControl
Press FANpad.Press LOWar HIGHpadsto set desired
fan speed.
Control Panel
Press the MODEpad untilthe FANindicatorlightis lit
and the LOWor HIGHindicatorlight islit for the desired
fan speed.