Table of Contents
Advertisement
Available languages
Available languages
Operating
the Dishwasher
Start the dishwasher:
1
Open the door and press the On/Off
button.
2
Select a cycle and desired
options.
3
Close the door to begin the cycle.
Delay start:
1
Open the door and press the On/Off
button.
2
Select a cycle.
3
Press and hold the Delay Start button.
Release when the desired delay time is shown in the display window.
4
Close the door to begin the cycle.
Cancel
a cycle:
1
Open the dishwasher door just far enough to expose the control panel. Be careful of hot water that may splash out.
2
Press and hold the two buttons
labeled Cancel/Reset
for 3 seconds.
3
Close the door and wait about 1 minute while the dishwasher
drains.
4
Open the door and press the On/Off
button.
You may now start a new cycle.
You could
be seriously
scalded
if you allow hot water to splash out of the dishwasher.
OPEN THE DOOR CARE-
FULLY during any wash or rinse cycle. Do not fully open the door until water noises have stopped.
Interrupt
a cycle:
1
Open the dishwasher door just far enough to expose the control panel. Be careful of hot water that may splash out.
2
Press the On/Off
button
to turn the unit off.
3
Wait at least 10 seconds
before fully opening
the dishwasher
door.
4
To resume the cycle, press the On/Off
button
and close the dishwasher
door.
Extra Dry Heat:
1
Press and hold the Auto button,
then press and hold the On/Off button.
2
When the LED display window
indicates
a "0" or "1" release both buttons.
3
To activate
Extra Dry Heat, press the Auto button
until the display indicates
"1".
4
To disable
Extra Dry Heat, press the Auto button
until the display indicates
"0".
5
Press the On/Off
button
to save the setting.
Cycle completion
signal:
The cycle completion
signal alerts you when a cycle completes
and the dishwasher
has washed
and dried the
dishes. You can choose to disable the tone or adjust the volume.
To activate:
1
With the unit OFF, press and hold the _
of the two Cancel/Reset
buttons
and then press and hold the On/
Off button.
2
When the light on the Cancel/Reset
button you are pressing illuminates and the tone goes off, release both buttons.
3
Press the _
of the two Cancel/Reset
buttons
again until you achieve the desired volume or until there is
no tone (to turn cycle completion
signal OFF).
4
Press the On/Off
button
to save the setting.
SHE55RF5UC,
SHE68R5xUC
and SHX68R5xUC
front display
key:
Check water inlet
Sensors OK Spray pressure
min_,k
_k
Do not open door
Sanitation
rinse
12
Washing
Rinsing
Drying
Program
progress
Hide quick links:
Advertisement
Chapters
Table of Contents
