Preparing, Loading And Operating Dispenser - Hamilton Beach 87330 Instructions Manual

Water dispenser for bottled water
Table of Contents

Advertisement

PREPARING, LOADING & OPERATING YOUR DISPENSER
1) Make sure that the dispenser is not plugged into the electrical outlet and that both the
HEATING and COOLING power switches (on the back of the dispenser) are set to the OFF
position.
NOTICE: To prevent leaking water due to damaged seals, do NOT turn ON the
HEATING switch without water in the dispenser.
2) Sanitize the dispenser water tanks prior to installing a full bottle of water for the first time
(see "Proper Care and Cleaning of Dispenser").
3) The water bottle will have a cap. The cap may have a stopper that is intended to be pushed
into the bottle. (Sometimes these stoppers are covered by a removable paper/foil seal.) If
your bottle has a cap with a stopper, simply hold the water bottle vertically straight upside
down and place the water bottle into the support collar on top of the water dispenser. The
post in the collar will push the stopper into the bottle.
If the water bottle cap does not have a stopper that is intended to be pushed into the bottle,
first remove the support collar of the water dispenser by turning it counterclockwise and
pulling it straight up and off. Then remove the spill-resistant piercing valve from the
support collar. Reinsert the support collar onto the water dispenser and turn it clockwise to
lock back in place.
Remove the cap from the water bottle. Quickly lift the water bottle, turn it upside down, and
place the water bottle onto the top of the water dispenser. Wipe up any water that spills on
to the water dispenser or floor.
4) Wait 5 minutes and then plug in the unit into a grounded power outlet (see "Grounding
Instructions"). Dispense 4 cups of water from each faucet.
5) Set the Heating and Cooling power switches (located on the rear of the dispenser) to the ON
position. Indicators light up accordingly once the dispenser is functioning.
6) Allow 4 hours for water to reach hot and cold temperatures.
Rotate counterclockwise
and pull straight off
6

Advertisement

Table of Contents
loading

Table of Contents