Cisco Catalyst 2960-XR Configuration Manual page 74

Configuring LLDP-MED TLVs
LLDP-MED TLV
location
network-policy
power-management
Beginning in privileged EXEC mode, follow these steps to enable a TLV on an interface:
SUMMARY STEPS
1. configure terminal
2. interface interface-id
3. lldp med-tlv-select
4. end
5. copy running-config startup-config
DETAILED STEPS
Command or Action
Step 1 configure terminal
Example:
Switch# configure terminal
Step 2
interface interface-id
Example:
Switch(config)# interface
gigabitethernet2/0/1
Step 3
lldp med-tlv-select
Example:
Switch(config-if)# lldp med-tlv-select
inventory management
Step 4
end
Example:
Switch(config-if)# end
Catalyst 2960-XR Switch Interface and Hardware Component Configuration Guide, Cisco IOS Release 15.0(2)EX1
62
Configuring LLDP, LLDP-MED, and Wired Location Service
Description
LLDP-MED location TLV
LLDP-MED network policy TLV
LLDP-MED power management TLV
Purpose
Enters global configuration mode.
Specifies the interface on which you are configuring
an LLDP-MED TLV, and enter interface configuration
mode.
Specifies the TLV to enable.
Returns to privileged EXEC mode.
OL-29420-01