Kenmore Ultra wave Microwave hood combination 665.61682 Use And Care Manual page 33

INSTALLING AND CARING FOR FILTERS
Electrical Shock Hazard
Disconnect power before removing filters.
Replace all panels before operating,
Failure to do so can result in death or
electrical shock,
The grease (aluminum) filters should be removed
and cleaned often, at least once a month.
You can order replacements (Part No. 8184001)
from your nearest Sears Service Center.
The 3M charcoal filter cannot be cleaned and
should be replaced every 6 to 12 months.
NOTE: Your microwave hood combination comes
with the 3M charcoal filter (Part No. 8184019)
installed behind the vent grille.
1. Unplug microwave oven or disconnect power.
2. To remove the grease filters (aluminum), push
each filter up on the
side opposite the tab.
Grasp the tab and slide
the filter to the side.
Pull the filter down-
ward. It will drop out.
3. Soak grease filters in hot
•
DISHWASHEP
CLEANER _ _
water and a mild deter-
gent. Scrub and swish to
remove embedded dirt
and grease. Rinse well and
shake to dry. Do not use
ammonia, corrosive clean-
ing agents such as lye-
based oven cleaners, or
place in a dishwasher. The
filter will turn black or could
be damaged.
4. To replace the grease filters, slide each filter
into the outer side of
the filter opening. Make
sure you are sliding in
the side of the filter that
does not have the tab.
Hold the tab with your
other hand. Push up the
tab side of the filter and
slide the filter to the
other side of the open-
ing to lock into place.
5. To remove the 3M charcoal filter, (located behind
vent grille) tilt the grille
forward, then lift out to
remove. Grasp
charcoal filter and lift
up and out of slot.
6. To replace the 3M charcoal filter, place new filter
in slot and replace
vent grille by snapping
it into place.
NOTE: See edge of
charcoal filter for cor-
rect orientation.
7. Plug in microwave oven or reconnect power.
NOTE: Do not operate the vent fan without the
grease filters in place.
33