Safety Instructions For Installation - Miele CS 1212-1 Operating And Installation Instructions

The appliance must only be installed
and connected to the electricity
supply by a suitably qualified and
competent person in strict
accordance with current national
and local safety regulations.
Fit the wall units and extractor hood
before fitting the hob to avoid
damaging the appliance.
~
The veneer or laminate coatings of
worktops (or adjacent kitchen units)
must be treated with 100 °C
heat-resistant adhesive which will not
dissolve or distort.
Any backmoulds must be of
heat-resistant material.
~
This appliance must not be used in
a non-stationary location (e.g. on a
ship).
~
After installation, ensure that the
connection cable is without hindrance
and that there is no mechanical
obstruction which could damage it,
such as a drawer.
~
The hob may only be built in over a
Miele oven if the worktop is at least
40 mm thick.

Safety instructions for installation

~
This appliance must not be installed
over a dishwasher, washing machine,
tumble dryer, refrigerator or freezer.
The high temperatures radiated by
hobs could damage the appliance
below.
~
The minimum safety distances given
on the following pages must be
observed.
All dimensions in this instruction booklet
are given in mm.
41