Cycle Selection Charts; Canceling A Cycle - Kenmore Elite Ultra Wash 665.1628 Series Use And Care Manual

Use cycles or options that add extra heat to the wash or rinse
portion of the cycle only when needed.
If your home is equipped with a water softener, you may want
to avoid starting the dishwasher during the regeneration of
the softener, since this may contribute to poor wash
performance.
Select the wash cycle and options desired. Or press START/
RESUME to use the same cycle and options as the previous
cycle.
NOTE: If the last cycle you completed was a rinse cycle, the
dishwasher will run the last full wash cycle and options that you
selected when you press START/RESUME.
A "O" shows the steps that are in each cycle.
Water usage is shown in U.S. gallons/liters.
These models meet the ENERGY STAR®guidelines for energy
efficiency.
IMPORTANT: These sensor-based cycles may take several
hours depending on cycle selected, water temperature, and soil
level sensed.
Smart Wash
Use this cycle for all day-to-day soil types when washing full to
partial dish loads. During the cycle, the sensors will determine
water temperature, wash time, and water amount based on the
soil level and the dish load size. During the main wash, the wash
action will repeatedly pause for several seconds.
Use both detergent dispenser sections when
washing a full soiled dish load.
Use one detergent dispenser section when
washing lightly soiled, partial dish loads.
Dish- Soil Wash Main Rinse Final Dry Approx- Water
load Level Wash or Rinse imate Usage
Sensed Purge Time (gal/L)
Full Heavy • • • • • 2.5 hrs* 5.6-6.5/
Purge 21.2-24,6
Light • • • • • 2 hrs* 5.6/21.2
Purge
Par- Heavy • • • • • 2 hrs* 5.6/21.2
tial Purge
Light • • • • • 1.5 hrs* 5.6/21.2
Purge
Pots Pans
Use this cycle for hard-to-clean, heavily soiled pots, pans,
casseroles, and regular tableware.
Use both detergent dispenser sections.
Wash Main Rinse Final Dry Approx- Water
Wash or Rinse imate Usage
Purge Time (gal/L)
• • • • • 2.5 hrs* 6.9-7.8/
Rinse 26.1-29.5
Normal Wash
Use this cycle for loads with normal amounts of food soil. (The
energy-usage label is based on this cycle.) During the wash
cycle, the wash action will repeatedly pause for several
seconds.
Use both detergent dispenser sections.
Wash Main Rinse Final Dry Approx- Water
Wash or Rinse imate Usage
Purge Time (gal/L)
• • • • • 2 hrs* 5.6-6.5/
Purge 21,2-24.6
China Gentle (on some models)
Use this cycle for china and crystal. This cycle uses a light
wash and gentle dry. During the heated dry, the heating
element cycles on and off.
Use main detergent dispenser section.
Wash Main Rinse Final Dry Approx- Water
Wash or Rinse imate Usage
Purge Time (gal/L)
• • • • •
1.5 hrs* 5.9-6.8/
Purge cycled 22.3-25.7
Quick Rinse (on some models)
Use this rinse cycle for rinsing dishes, glasses, and silverware
that will not be washed right away.
_ Do not use detergent with this cycle.
Wash Main Rinse Final Dry Time Water
Wash or Rinse (rain) Usage
Purge (gal/L)
• 10 1.8-2.2/
Rinse 6.8-8.3
*If the incoming water temperature is less than the
recommended temperature or food soils are heavy, the cycle will
automatically compensate by adding time, heat and water as
needed.
1. Carefully open the door slightly to stop the cycle. Wait for the
spraying action to stop before opening the door to access the
control panel.
2. Press CANCEL/DRAIN. The Cancel light glows.
3. Close the door. The dishwasher starts a 2-minute drain (if
needed). Let the dishwasher drain completely. The light turns
off after 2 minutes.
To stop the drain
You can press CANCEL!DRAIN again to stop the drain.
Remember to drain the dishwasher before starting a new cycle.
Press CANCEL!DRAIN before starting the dishwasher to clear all
options and cycles.
15