3. INSTALLATION & OPERATION
1. Unscrew the Set Screw using the supplied Hexagon Wrench and then
remove the Outer Housing from the Camera Base.
2. Paste the supplied mounting template onto a desired location on the
ceiling / wall. Drill the four small holes for screwing the camera with
the supplied Screws and Anchors, and the circle in the middle only if
you wish to run the wires into the wall.
3. Insert the supplied 4 Anchors into the 4 holes on the ceiling / wall.
4. Screw the Camera Base to the ceiling / wall using the supplied 4
Screws.
a. If you want to wire the cables from the side cut of the Camera
Base, run the cables through the Camera Base first, attach and
then screw the Camera Base to the ceiling / wall.
4
EBD431e