Table of Contents
Advertisement
NetVanta 6355 PoE Hardware Installation Guide
Installing Network and Voice Interface Modules
NIMs/VIMs are installed into the rear panel option module slot. The following tables list the installation steps.
Also see
Figure 16 on page
For NetVanta modules with outside plant connections, ensure that all cables are
removed from the module before installing or removing it from the NetVanta chassis.
Always remove power from the unit and all telecommunication connections prior to
removing or installing a module.
Improper installation may result in damage to the modules.
Step
1
Remove power from the unit.
2
Remove the cover from the option slot by pulling the pins until they disengage from the chassis.
3
Slide the option module into the option slot until the module is firmly seated against the chassis.
4
Secure the pins at both edges of the module.
5
Connect the cables to the associated device(s).
6
Restore power to the unit.
CF
61200740E1-34D
39.
Instructions for Installing the NIMs/VIMs
SLOT 1
SLOT 2
Figure 16. NIM/VIM Installation
Copyright © 2011 ADTRAN, Inc.
Action
MOH
0/1
0/2
0/1
0/2
ETH 0/0
PAGE
ANALOG STA
ANALOG TRK
Unit Installation
100-250 VAC
50-60Hz
DOOR
CONSOLE
RELAY
NC NO COM
39
Advertisement
Table of Contents
