Table of Contents
Advertisement
NetVanta 6355 PoE Hardware Installation Guide
5.
UNIT INSTALLATION
The instructions and guidelines provided in this section cover hardware installation topics, such as mounting
options, supplying power to the unit, and installing option cards. These instructions are presented as follows:
•
Mounting Options on page 36
•
Supplying Power to the Unit on page 38
•
Installing Network and Voice Interface Modules on page 39
•
Using a USB Cellular Modem with the NetVanta USB WWAN NIM on page 40
•
Installing the NetVanta VPN Accelerator Card (included in P/N 4200368L1) on page 41
•
Installing a CompactFlash Card on page 42
For information on switch configuration for a specific application, refer to the configuration guides provided on
the
ADTRAN Support
Community. For details on the command line interface (CLI), refer to the
AOS Command Reference
http://supportforums.adtran.com.
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm.
Electronic modules can be damaged by static electrical discharge. Before handling
modules, put on an antistatic discharge wrist strap to prevent damage to electrical
components. Place modules in antistatic packing material when transporting or storing.
When working on modules, always place them on an approved antistatic mat that is
electrically grounded.
The NetVanta 6355 PoE is intended to be installed, maintained, and serviced by qualified
service personnel only and should be installed in a restricted access location as described
in UL/IEC 60950-1.
• Ethernet cables are intended for intrabuilding use only. Connecting an ADTRAN unit
directly to Ethernet cables that run outside the building in which the unit is housed will
void the user's warranty and could create a fire or shock hazard. To connect an
ADTRAN unit to Ethernet cables that run outside the building, ADTRAN's Ethernet
Port Protection Device (EPPD) (P/N 1700502G1) must be connected between the unit
and the outside plant cable. Use of any Ethernet protector other than ADTRAN's for this
purpose will void the user's warranty.
• PoE cables are intended for intrabuilding use only. Connecting an ADTRAN PoE unit
directly to PoE cables that run outside the building in which the unit is housed will void
the user's warranty and could create a fire or shock hazard.
• For outdoor PoE applications, ensure any PoE injector used is approved and rated for
outdoor/exposed wiring applications. Use of a PoE injector that is not rated for
outdoor/exposed wiring applications will void the user's warranty and could create a
fire or shock hazard.
61200740E1-34D
Guide. All other related documents are also available online at
Copyright © 2011 ADTRAN, Inc.
Unit Installation
35
Advertisement
Table of Contents
