Features Setup - ECS PT880PRO-A Manual

32

Features Setup

This page sets up some parameters for peripheral devices connected to the system.
OnBoard Floppy Controller
Serial Port1 Address
Onboard IR Port
Parallel Port Address
Parallel Port Mode
ECP Mode DMA Channel
Parallel Port IRQ
OnBoard PCI IDE Controller
OnBoard SATA-IDE
Audio Device
Modem Device
Ethernet Device
Onboard LAN Boot ROM
Onboard USB Function
USB Function For DOS
F1:General Help
OnBoard Floppy Controller (Enabled)
Use this item to enable or disable the onboard floppy disk drive interface.
Serial Port1 Address (3F8/IRQ4)
Use this item to enable or disable the onboard COM1 serial port, and to assign a port address.
Onboard IR Port (Disabled)
Use this item to enable or disable the onboard IR port function.
Parallel Port Address (378)
Use this item to enable or disable the onboard Parallel port, and to assign a port address.
Parallel Port Mode (ECP)
Use this item to select the parallel port mode. You can select Normal (Standard Parallel
Port), ECP (Extended Capabilities Port), EPP (Enhanced Parallel Port), or BPP (Bi-
Directional Parallel Port).
ECP Mode DMA Channel (DMA3)
Use this item to assign the DMA Channel under ECP Mode function.
Parallel Port IRQ (IRQ7)
Use this item to assign IRQ to the parallel port.
OnBoard PCI IDE Controller (Both)
Use this item to enable or disable either or both of the onboard Primary and Secondary IDE
channels.
CMOS Setup Utility - Copyright (C) 1985-2004, American Megatrends, Inc.
Features Setup
Enabled
3F8/IRQ4
Disabled
378
ECP
DMA3
IRQ7
Both
RAID
Enabled
Auto
Enabled
Disabled
Enabled
Disabled
: Move Enter : Select +/-/: Value
F9: Optimized Defaults
Using BIOS
Help Menu
Allow BIOS to Enable or
Disable Floppy Controller.
F10: Save
ESC: Exit