Table of Contents
Advertisement
Figure 31 Displaying digital channels in a "bus" display mode.
You should now see a "bus" display mode showing HEX values of the
D7- D0 bus at the bottom of the scope's display similar to
that it addition to specifying a pattern trigger condition in a binary
format, we can also specify to trigger on a pattern condition as a HEX
value. The HEX value of the input to the DAC when the output is at its
lowest amplitude is 1A
18
19
20
21
22
23
2000 X-Series Oscilloscopes Advanced Training Guide
Advanced Triggering, Search & Navigation, and Segmented Acquisition Labs
HEX
Press the [Trigger] front panel key.
Press the Channel softkey; then select Bus1 using the Entry knob.
Press the Digit softkey; then select 1 using the Entry knob.
Press the Hex softkey; then select 1 using the Entry knob.
Press the Digit softkey; then select 0 using the Entry knob.
Press the Hex softkey; then select A using the Entry knob.
. Let's now specify to trigger on 1A
3
Figure
31. Note
.
HEX
51
Advertisement
Table of Contents
