Reversible Door Instructions - Kenmore Sears refrigerator Owner's Manual

Reversible Door
Instructions
NOTE: Some models have "pocket"
handles, which are recessed into the
side of the door On these models,
only the hinges will need to be re-
versed A handle is built into both
sides of each door
1. Refer to the Toe Grille Assembly
Instruction Sheet in the literature pack to
remove the Toe Grille (some models)•
Snap off hinge cover at top of cabinet
(some models) With the freezer door
closed, remove the two screws attaching
upper hinge to cabinet Lift the hinge up
and off. Be sure to save screws and
hinge for reassembly later.
Hinge Pln
Lower Hinge crews
or
Washer
_£)_ Htlnge
Pin
Lewe/Hinge Screws
4. Remove hinge pin, hinge, and the two
screws attaching the lower hinge Save
the hinge, hinge pin, washer (some
models) and screws for reassembly
later.
Your refrigerator is equipped with convertible door hinges Hinging of the door can
be changed to the opposite side any time you wish An envelope containing extra
plastic hole plugs is included in some models Turn the refrigerator control to OFF,
Remove all food, bottles, and other items from the door Begin with freezer door
Completely remove one door before beginning the other,
Tools Necessary: ,_ _ !_ P_t_/
Phllll
S__:_ I )R__!_O
Adlu_oblo
screwdriver Wrench Set U _ Wrench
Pin
3, With the refrigerator door closed,
remove center hinge pin (Note the
arrangement of the upper and lower
washers (some models) on the hinge pin
The washers must be assembled later in the
same manner) Open refrigerator door
enough to allow door to be lifted off the
lower hinge Remove the two screws
attaching the center hinge The third
outermost screw under the center hinge
should be left in place Save hinge, pin,
and washers (some models) for
reassembly later. Reinstall screws in
original holes
5. Carefully remove the hole plugs from
the hinge holes in the center mullion and
top of cabinet and reinstall in the
opposite set of holes
_ Screws
Freeze_ Door
d
,_ _<-- Screw
Refrigerator Door
6. After the handles a_e removed (see
steps 7 and 8), remove door stop from
bottom of freezer and refrigerator door
and reinstallon opposite side