First Steps - Kenmore Sears refrigerator Owner's Manual

_ - _- __
First Steps
3= AIR SPACE
Clearance
Proper air circulation and leveling will
ensure efficient operation
Screw_type Levelers (some models)
LOWER
CABINET
CABINET
Exposed bolt (some models)
LOWER
CABINET
CABINET
Sunken bolt (some models)
Before starting the refrigerator, follow these important first steps:
Location
Choose a place that is near a grounded electrical outlet, DO NOT use an
extension cord or an adapter plug
= If possible, place the refrigerator out of direct sunlight and away from the
range, dishwasher or other heat sources
• The refrigerator must be installe_don a floor that is level and strong enough
to support a fully loaded refrigerator
• Consider water supply availability for models equipped with an automatic ice
maker
Installation
• Do not install the refrigerator where the temperature wilt drop below 60°F
(t 5°C) or rise above t 10% (43°C) The compressor will not be able to maintain
proper temperatures
= Allow space around the unit for good air circulation, Leave a ! inch (25 ram)
space behind and a 3 inch (75 ram) space above the refrigerator for adequate
circulation
• In a recessed installation, allow an extra t/2 inch (10-15 ram) on each side
for ease of installation
o For best circulation, elevate the unit 1 inch (25 ram) from the floor, especially
if the floor is carpeted
Door Opening
The doors should open to allow easy access to a counter when removing food
- Do not position the refrigerator so you have to walk around the refrigerator
doors
• Reversethe doors if necessary See "Reversible Door Instructions,"
Leveling
All four corners of refrigerator must rest firmly on a solid floor, Some models are
equipped witln adjustable screw-type levelers Others are equipped with rolters If
your refrigerator did not come with rollers, they can be purchased from your dealer
Refer to the Toe Grille Assembly Instruction Sheet in the literature pack to remove
the Toe Grille (some models),
• To adjust screw-type levelers (some models): Tip cabinet back slightly and
raise adjusting bolts as needed,
° To adjust front rollers (some models): Use a screwdriver, 3/8" socket
wrench, or nutdriver to adjust rollers as shown,
RAISE THE FRONT of cabinet enough so doors will close freely when opened
halfway Levelcabinet sideto side Referto the Toe Grille Assembly Instruction Sheet
in the literature pack to replace the Toe Gritle (some models),
Cleaning
o Wash the inside, all removable parts and the outside with mild detergent and
warm water Wipe dry DO NOT USE HARSH CLEANERS ON THESE
SURFACES°
• Do not use razor blades or other sharp instruments which can scratch the
appliance surface, when removing adhesive labels, Any glue left from the
tape or energy label can be removed with a mixture of warm water and mild
detergent, or touch the residue with the sticky side of tape already removed,
. DO NOT REMOVETHE SERIALPLATE