Power Supply; Installation; Before First Use Maintenance Wash; Error Code Failure System - Baumatic BFWM1406W 60 cm6kg Instruction Manual

 The moulded plug that is supplied with the appliance must be
placed into an earthed and insulated socket.
 Broken or damaged power leads must only be replaced by a
suitably qualified person. A power lead of a similar type must be
used in replacement.
 IMPORTANT: We do not recommend that this appliance is
connected to an extension lead.

Before first use maintenance wash

o When your washing machine has been correctly installed, we
recommend that you perform a high temperature wash cycle,
without any clothing being placed inside of the drum.
o This will check that all aspects of the installation are correct;
it will also remove any deposits that may have been left on
the drum by the manufacturing process.

Error code failure system

If your appliance senses that it is not operating correctly, then an error
code may appear on the LED display.
The following error codes can possibly be remedied by the customer
and the steps outlined below should be followed.
BEFORE COMPLETING
APPLIANCE, IT SHOULD BE DISCONNECTED FROM YOUR

POWER SUPPLY.

Error Reason
code
Inlet water overtime.
Overtime of the
drainage.
The door has not
been closed.
Other
ANY MAINTAINEANCE
Solutions
Open the water tap to check if the inlet
o
hose is squashed or kinked.
Check if the filter in the inlet valve is
o
blocked or not.
Check if the water pressure is too low.
o
Check if the drain pump is blocked (see
o
relevant section).
Check if the door of the washing machine
o
is closed.
Check if the clothes are preventing the
o
door from closing properly.
Contact the Customer Care Department.
o
ON THE
33