Cleaning the water inlet filter
o Clean the filter approximately every 6 months, when water leaks
from the water inlet, or if there are frequent interruptions to
your water supply.
o Always pull the power plug out before cleaning.
Winter storage
o You should install your appliance in a location where it will not be
subjected to freezing temperatures.
o If you are going to store your appliance in a location where the
temperature will drop below freezing in winter, then you should
follow the table below.
To winterize the washer
Turn off the water supply.
Disconnect and drain the water
inlet hoses.
Run the washer on a drain and
spin setting for one minute.
Unplug the power supply cord.
1) Unscrew the inlet water pipe.
1) Use long-nose pliers to remove the water
inlet filter
2) Clean carefully with a gauze brush and then
replace.
To use the washer again
Flush the water pies
and hoses.
Reconnect the water
inlet hoses.
Turn on the water
supply.
Reconnect the power
supply cord.
24