Darning - Pfaff 1529 Owner's Manual

D
C
B
E
F
G
Darning with the straight stitch
Insert the darning foot:
Loosen screw D. Set the needle at its
highest point and push the pin of the
darning foot fully into the hole C of the
sewing foot holder. When doing this,
the guide fork G should position itself
around the presser bar. The lever E must
be behind the xing screw F. Now tighten
screw D.
Darning position:
Lower the presser foot lifter (A) while
A
pushing it lightly to the rear. This snaps
the presser foot lifter into a notch (B) on
the back side of the sewing machine into
the darning position.
• Place the darning work in the darning
hoop.
• Drop the feed dog.
• Pull up the bobbin thread and hold
the threads when you start sewing.
• Darn the damaged area by guiding
the fabric back and forth evenly in the
prescribed direction while ensuring that
each line ends with a small curve. This
helps to avoid the fabric ripping again.
• When you have nished sewing the
damaged area, rotate the fabric again.
You determine the stitch length yourself
by moving the fabric back and forth.
Tip: If you move the fabric too slowly, small
knots will appear on the reverse side of the
fabric.
Utility stitches and practical sewing
G 0 –
E 0 –
E 0 –
2:17
2-3 6
2-3 Optional
2-3 Optional