Pfaff 1529 Owner's Manual page 18

1:6 Operate your Pfaff select
Winding from the second spool holder
Push the second spool holder (7) into its
hole and place a spool of thread with the
corresponding spool cap on it.
B
Threading
A
Place the thread into guide A and pull
it through opening B to the right under
hook C. Wind the thread clockwise a few
times around the bobbin.
Switch on the main switch
Hold the end of thread rmly and press
the the foot control. The winding action
will stop automatically as soon as the
bobbin is full.
Cut the thread, push the bobbin to the left
and remove it.
Don't forget:
Turn the handwheel release disk (3)
back again. Then turn the handwheel (4)
towards you until it snaps into place.
TIP: If the machine is already threaded,
you can easily wind thread from the second
C
spool holder without having to unthread the
machine.
1:6