Indoor Unit Installation Drawings - Daikin FTXN15KVJU Installation Manual

Indoor Unit Installation Drawings

B Mounting plate fixing screw
3/16" × 1" (M4 × 25mm)
Front panel
1-15/16" (50mm)
or more
from walls
(on both sides)
Air filters
C Titanium apatite photocatalytic
air-purifying filter (2)
Filter frame
Tab
4
1-3/16" (30mm) or more
from ceiling
3/16" × 5/8"
(M4 × 16mm)
Opening service lid
Service lid is opening/closing type.
Opening method
3/16" × 5/8"
(M4 × 16mm)
Titanium apatite
photocatalytic
air-purifying filter
Air filter
How to attach the indoor unit
Hook the claws of the bottom frame
to the mounting plate.
If the claws are difficult to hook,
remove the front grille.
How to remove the indoor unit
Push up the marked area (at the
lower part of the front grille) to
release the claws. If it is difficult to
release, remove the front grille.
A Mounting plate
Service lid
1) Remove the service lid screws.
2) Pull out the service lid diagonally
down in the direction of the arrow.
3) Pull down.
F Fixing screw for remote
controller holder
1/8" × 13/16" (M3 × 20mm)
Front grille
The mounting plate
should be installed on a
wall which can support the
weight of the indoor unit.
Cut thermal insulation
pipe to an appropriate
Caulk
length and wrap it with
pipe hole
tape, making sure that no
gap
gap is left in the insulation
with putty.
pipe's cut line.
Wrap the thermal insulation
pipe with the finishing tape
from bottom to top.
Before screwing the remote
D
controller holder to the wall,
Wireless
make sure that control
remote
signals are properly
controller
received by indoor unit.
Remote
controller holder
A Mounting
plate
Clip
Bottom frame
Mark (rear side)
E
■English