Operating Chain Saw - Remington Branch Wizard RM0612P Owner's Manual

OPERATING POLE SAW
A WARNING: Read and understand this
owner's manual before operating tNs Pole
Saw. Make certain you read and under-
stand all Important Safety Information.
Improper use of this Pole Saw can cause
severe injury or death from fire, electri-
cal shock, or body contact with moving
chain or falling wood.
EXTENSION CORDS
Use proper extension cords with this Pole Saw. Use
only extension cords marked for outdoor use. The
cord must be marked with suffix W or W-A follow-
ing the cord type designation. Example: SJTW-A
or SJTW.
Use proper sized cord with this Pole Saw. Cord
must be heavy enough to carry current needed. An
undersized cord will cause voltage drop at Pole Saw.
Pole saw will lose power and overheat. Follow cord
size requirements listed below.
Cord Length AWG Cord Size
25 feet 16 AWG
50 feet 16 AWG
100 feet 16 AWG
150 feet 14 AWG
OiLiNG CHAIN
This Pole Saw requires lubrication only to prevent
rust on the guide bar and saw chain. The saw chain
provided is pre-lubricated at the factory. With each
use of the Pole Saw apply a small amount of lubricat-
ing oil directly to the saw chain (see Figure 8). The
oil will distribute itself around the chain and guide
bar groove during use-preventing rust. We recom-
mend using SAE #30 motor oil for lubrication and
rust prevention.
Chain Oil
%(" ( ,, J
_f ,,
Figure 8 - Oil Chain and Guide Bar
Keep cord away from cutting area. Make sure cord
does not catch on branches or logs during cutting.
Inspect cords often. Replace damaged cords.
The extension cord may come undone from the power
cord during use. To avoid this, make a knot with the
two cords as shown in Figure 7.
Chain Saw Power Cord
Figure 7 - Tying Extension Cord and Power
Cord in Knot
10