Operating Chain Saw; Extension Cords; Adjusting Pole Length - Remington RPS2N1: 106821A Owner's Manual

ASSEMBLY
Continued
❸
Step – Attach Handle Bracket to
Pole Bracket
Slide handle bracket onto
3A
clamping bolt.
3B
❹
Step – Secure Handle Bracket to
Pole Bracket
Thread knob onto clamping bolt. Note: After knob
4B
makes contact with handle bracket, tighten 1
2 more turns.
❺
Step – Connect to Power Cord
Plug saw power cord into receptacle cord at end of
5A
inner pole.
111219
Clamping bolt should extend
through handle bracket
Place lockwasher
4A
onto clamping bolt.

OPERATING CHAIN SAW

WARNING: Read and understand this
owner's manual before operating this Pole
Saw. Make certain you read and under-
stand all Important Safety Information,
pages 2 through 4. Improper use of this
Pole Saw can cause severe injury or death
from fire, electrical shock, or body contact
with moving chain, or falling wood.

EXTENSION CORDS

Use proper extension cords with this Pole Saw. Use
only extension cords marked for outdoor use. The cord
must be marked with suffix W or W-A following the
cord type designation. Example: SJTW-A or SJTW.
Use proper sized cord with this saw. Cord must be heavy
enough to carry current needed. An undersized cord
will cause voltage drop at saw. Saw will lose power and
overheat. Follow cord size requirements listed below.
Cord Length
25 feet
50 feet
100 feet
150 feet
Keep cord away from cutting area. Make sure cord
does not catch on branches or logs during cutting.
Inspect cords often. Replace damaged cords.
The extension cord may come undone from the power
cord during use. To avoid this, make a knot with the
two cords as shown in Figure 5.

ADJUSTING POLE LENGTH

1 / to
2
The Remington Pole Saw has a telescoping pole as-
sembly that will extend from 57 inches (fully re-
tracted) to 96 inches (fully extended). A cam levered
collet is used to hold the pole in position at any ex-
tended length.
1. To extend the pole, loosen the clamping lever as
shown in Figure 6. Pole will slide freely.
2. Pull inner pole section out to desired length of
extension. Note: Only extend pole to minimum
length required to reach limb that is being cut.
3. To lock pole in position, tighten clamping lever as
shown in Figure 6.
15
AWG Cord Size
16 AWG
16 AWG
16 AWG
14 AWG
Continued
www.desatech.com