Assembly - Remington Branch Wizard RM0612P Owner's Manual

ASSEMBLY
IMPORTANT: Read and understand this
manual before assembling or operat-
ing this Pole Saw. improper use of Pole
Saw can cause severe injury. Keep this
manual for future reference.
Note: Some models are pre-assembled. Assembly
is not needed on these models.
See Saw Chai17TelTsio,7 Adjustmem.
WARNING: Cutting edges on chain
are sharp. Use protective gloves when
handling chain.
[ ,MPORTANT: Do not c,amp Po,e Saw in ]
vise during assembly.
£k
CAUTION: Do not place chain on saw
backwards, if chain is backwards, saw
will vibrate badly and will not cut.
5. Place Belleville washer, sprocket cover, and
guide bar nut onto Pole Saw. IMPORTANT,"
Make sure serrated edge of the Bdleville washer
is positioned as shown in Figure 3. The serrated
edge must be in contact with the guide bar.
IMPORTANT,"Tighten guide bar nut lingertight
only.
6. Adjust saw chain tension. Follow steps under
Saw Chai_7_._7sio_7
A djustmelTt.
Guide Bar
Serrated Edge Against tj _
Guide Bar
1.
2.
3.
4.
Lay chain out fiat.
Loosen and remove guide bar nut, sprocket
cover, and washer (see Figure 1).
Install guide bar onto saw body. Place center slot
of guide bar onto guide bar bolt.
Place chain around drive sprocket, then along
top groove of guide bar and around guide bar
nose. Note: Make sum cutting edges of chain
are facing the right direction. Position chain so
cutting edges on top of guide bar face guide bar
nose (see Figure 2 and indicator on side cover
of Pole Saw).
Belleville Washer
Figure 3 - Belleville Washer Assembly
Guide Bar
/
/
/
/
Belleville Washer
Figure 1 - installing Guide Bar
Towards Guide Bar Nose /.._
Guide Bar
Nut
/
/
/
\
Bushing
Sprocket Cover
_uttmg Edge
J_'Saw Chain
Figure 2 - Chain Position