Table of Contents
Advertisement
ENGAGEMENT
Autopilot engagement/disengagement is not equivalent to servo engagement/disengagement. Use
NOTE:
the CWS Switch to disengage the pitch and roll servos while the autopilot remains active.
When the AP Key is pressed, the autopilot, yaw damper, and flight director (if not already active) are activated.
The flight director engages in Pitch and Roll Hold Modes when initially activated. When the YD Key is pressed,
the system engages the yaw damper independently of the autopilot (if not already engaged). Autopilot and yaw
damper status are displayed in the center of the AFCS Status Box. Engagement is indicated by green 'AP' and
'YD' annunciations, respectively.
CONTROL WHEEL STEERING
During autopilot operation, the aircraft may be hand-flown without disengaging the autopilot. Pressing and
holding the CWS Switch disengages the pitch and roll servos from the flight control surfaces and allows the
aircraft to be hand-flown. At the same time, the flight director is synchronized to the aircraft attitude during
the maneuver. CWS activity has no effect on yaw damper engagement.
The 'AP' annunciation is temporarily replaced by 'CWS' in white for the duration of CWS maneuvers.
In most scenarios, releasing the CWS Switch reengages the autopilot with a new reference. Refer to flight
director mode descriptions for specific CWS behavior in each mode.
190-00595-01 Rev. B
Autopilot
Yaw Damper
Engaged
Engaged
Figure 7-26 Autopilot and Yaw Damper Engaged
Control Wheel Steering
Figure 7-27 CWS Annunciation
Garmin G1000 Pilot's Guide for the Beechcraft A36/G36
AUTOMATIC FLIGHT CONTROL SYSTEM
359
Advertisement
Table of Contents
