Display The Phone Configuration Web Page; Configuration Web Page" Section On Page; Assigning An Ip Address - Cisco Access Registrar 4.2 Configuring Network Settings

Configuring IP Settings
Note

Assigning an IP Address

Using the Phone Configuration Web Page
Step 1
Step 2
Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 4.2, Cisco Unified IP Phone
4-18
You can use 0.0.0.0 for the subnet mask only if the default gateway is also
•
0.0.0.0.
Ensure the TFTP server has an IP address.
•
Ensure the default gateway IP address is on the same subnet as the host IP
•
address.
Procedures involved in configuring IP settings or TFTP options cannot be
completed when DHCP is enabled in your network.
This section covers the following topics:
Assigning an IP Address, page 4-18
•
• Assigning a Default Router, page 4-19
Assigning a Subnet Mask, page 4-21
•
Assigning a Domain Name, page 4-22
•
Assigning DNS Servers, page 4-24
•
The IP address is the unique logical address identifying each host computer, or
node, on a TCP/IP network. An IP address is a 32-bit number expressed as four
decimal numbers from 0 to 255 separated by periods.
Before you can assign an IP address, you must disable DHCP. For instructions,
see the "Disabling DHCP" section on page
To assign an IP address for the Cisco Unified IP Phone, follow these steps:
Procedure
Display the Phone Configuration web page.
For instructions, see the
Configuration Web Page" section on page
In the pane on the left under Change Configuration, click Network Parameters.
Chapter 4 Configuring Network Settings on the Cisco Unified IP Phone
4-15.
"Accessing Network Settings through a Phone
4-2.
OL-8617-01