Table of Contents
Advertisement
Getting through
narrow
spaces
If your refrigerator
will not fit through an
entrance area, you can remove the doors.
Check first by measuring the entrance.
To prepare for rernovin9
the doors:
1 Flake sure the electrical power cord is
unplugged from the wall outlet.
2 Open the freezer drawer and remove the
toe grille (see "Installation"
section).
3 Remove any food from the door shelves
and close the doors.
To remove the top hinge covers:
1 Remove the two screws from each cover
over the top door hinges,
2 Lift inside edge of hinge cover and tilt back.
Front
Rear
Cover
Top Hinge
Screw
Cc
Hinge
Ground
Multi-wire
Cables
Leave
Hinge
With <
Door
Top
Hinge
Rear
Front
Cover Screw
Screw
Top Hinge
To remove the refrigerator
doors:
1 Trace lightly around the door's top hinges
with a pencil. This makes reinstallation
easier.
Disconnect the harness by grasping both
sides of the connector firmly, depress the
latch, and pull apart. Remove the two
screws from the top hinge. Lift the door
off of the bottom hinge and set it aside.
TOnP a
Ground
e Screw
,,,,,
Hinge
Screws
©\ _
Two Wire
_
Cables
DO NOT remove the ground screw from
hinge.
Advertisement
Table of Contents
