ZyXEL Communications GS1910 User Manual page 31

Table 4 Navigation Panel Links (continued)
LINK
MLD Snooping
LLDP
Neighbours
LLDP-MED
Neighbours
EEE
Port Statistics
MAC Table
VLANs
VLAN
Membership
VLAN Port
Stack
VCL
MAC-based
VLAN
sFlow
sFlow Statistics
Diagnostic
Ping
Ping6
VeriPHY
Maintenance
Restart Device
Factory Defaults
Software
Upload
Image Select
Configuration
Backup
Upload
GS1910/XGS1910 Series User's Guide
DESCRIPTION
This link takes you to a screen where you can view MLD snooping status, MLD group
information and SFM (Source-Filtered Multicast) information..
This link takes you to a screen where you can view the LLDP neighboring device
information.
This link takes you to a screen where you can view the LLDP-MED neighboring device
information.
This link takes you to a screen where you can view the EEE information exchanged via
LLDP.
This link takes you to a screen where you can view LLDP traffic statistics on the Switch or
on a port.
This link takes you to a screen where you can view the MAC address and VLAN ID of a
device attached to a port. You can also view what kind of MAC address it is.
This link takes you to a screen where you can view status of the VLAN group.
This link takes you to a screen where you can view detailed VLAN settings on a port.
This link takes you to a screen where you can see whether stacking is enabled on the
Switch.
This link takes you to a screen where you can view the MAC-based VLAN settings.
This link takes you to a screen where you can view sFlow receiver state and sFlow packet
statistics on each port.
This link takes you to a screen where you can ping IPv4 addresses to test connections.
This link takes you to a screen where you can ping IPv6 addresses to test connections.
This link takes you to a screen where you can perform a physical wire-pair test of the
Ethernet connections on the specified port(s).
VeriPHY® cable diagnostics provide extensive network cable information such as cable
length, termination status, and open/short fault location.
This link takes you to a screen where you can reboot the system without turning the
power off.
This link takes you to a screen where you can to reset the Switch back to the factory
defaults.
This link takes you to a screen where you can upload firmware to the Switch.
This link takes you to a screen where you can switch to use a second firmware image if
available.
This screen is not available on the XGS1910-24 or XGS1910-48.
This link takes you to a screen where you can back up your current Switch configuration
to a computer.
This link takes you to a screen where you can restore a previously saved configuration
from your computer to the Switch.
Chapter 4 The Web Configurator
31