Using a #2 Philips screwdriver, install the M3 flat head screws through the
2
mounting bracket holes into the Switch.
Repeat steps
3
the Switch.
You may now mount the Switch on a rack. Proceed to the next section.
4
2.2.3 Mounting the Switch on a Rack
Position a mounting bracket (that is already attached to the Switch) on one side of
1
the rack, lining up the two screw holes on the bracket with the screw holes on the
side of the rack.
Figure 7 Mounting the Switch on a Rack
Using a #2 Philips screwdriver, install the M5 flat head screws through the
2
mounting bracket holes into the rack.
Repeat steps
3
the rack.
GS1910/XGS1910 Series User's Guide
1
and
2
to install the second mounting bracket on the other side of
1
and
2
to attach the second mounting bracket on the other side of
Chapter 2 Hardware Installation and Connection
13