Table of Contents
Advertisement
28
X.25 Menus: X.25 Frame Level Menu
X.25 Frame Level Menu
Device: DEV050607
Option
1. Interface type
2. Network type
3. Speed
4. Path cost
5. Retry timer
6. Retry count
7. CD wait time
8. Extended buffering
9. Compression
Enter option number, "=" - main menu, <TAB> - previous menu
>
The X.25 FRAME LEVEL MENU allows the setting of various X.25 frame level parameters used for the link
configuration.
Interface Type - Option 1
This option allows you to define the logical interface type of the X.25 link. This affects the organization of
incoming and outgoing calls. Outcall channels on a logical DTE correspond to incall channels on a logical DCE
(see the attributes Incall Channel Range Begin and Outcall Channel Range Begin).
Default:
[DTE]
Network Type - Option 2
This option allows you to define the type of X.25 network the link is connected to.
When the Network Type is changed, a Soft Reset must be performed for this to take effect. This allows the
bridge/router to initiate operation with the new network type.
Default:
[telenet]
Choices:
telenet, tymnet, datapac80, datapac84, transpac, dataxp, datanet1, pss, ddn, other
X.25 FRAME LEVEL MENU
Value
[DTE]
- Configure interface type
[telenet]
- Select network type
[64 kbps]
- Set link timing
[auto]
- Define link routing cost
[5000 msec]
- Wait before frame considered lost
[3]
- Resend unacked frame [x] times
[60 sec]
- Wait for modem CD signal
[disabled]
- Increase link buffering
[enabled]
- Activate data compression
DI-1135 X.25 Bridge/Router Menu Reference Manual
Description
V XTF5.9.X
Advertisement
Table of Contents
