Table of Contents
Advertisement
Changing Hardware
Interfaces
The FreeAgent™ Pro is equipped with an interchangeable USB/eSATA, or 1394 module.
The module is fastened to the base of the unit with a screw. The slot on the screw is curved
to accommodate the edge of a coin. We recommend using a coin as a screwdriver when
swapping interface modules.
Switching USB/eSata - 1394 Interfaces
Warning: Do not use a regular screwdriver to perform this operation.
To switch from one interface to another,
Step 1: Turn the drive off and remove all cabling.
Step 2: Flip the unit over and use a coin to loosen the screw by turning it counterclockwise.
.
Step 3: After the screw is completely loose, use your fingernails to grasp the screw head
FreeAgent Pro Data Mover
Use your fingers to unscrew it the rest of the way.
Figure 1:
Loosen Module Screw
and lift the module straight up from the base:
12
Advertisement
Table of Contents
