Operating Instructions - Kenmore 116.34922 Owner's Manual

CORD ASSEMBLY
Make sure the quick release upper cord
hook is in the upright position. Remove the
wire tie from the power cord.
Lock the power cord
into the locking notch
base by pressing it
into the quick release
upper cord hook as
shown. This helps keep
the power cord out
from under the vacuum
cleaner agitator.
Power
Quick Release
Lower
Cord Hooks II
Wrap the power cord around the upper and
lower cord hooks and lock the power cord
plug onto the power cord,
OPERATING INSTRUCTIONS
HANDI-MATE JR.®
For operation of Handi-Mate Jr.® see
separate Owner's Manual.
Latch
•Caddy
Handi.Mate Jr,®
TO INSERT HANDI-MATE JR ®
Place the rear of the Handi-Mate Jr.® into
the caddy. Rotate the Handi-Mate Jr. ®
back until it snaps into place.
TO REMOVE HANDI-MATE JR. ®
Rotate Handi-Mate Jr.e out of the caddy.
3. Be sure the vacuum cleaner has bag
installed. See DUST BAG REPLACEMENT.
4. Plug the polarized power cord intoa 120
Volt outlet locatednear the floor.
5. To replace cord,turn upper hook counter°
clockwisepointing up, then wrap cord.
Personal Injury and Product Damage
Hazard
• DO NOT place hands or feet under
the unit at any time.
• DO NOT use outlets above coun-
tsrs. Damage from cord to Items In
surroundln_ area could occur.
6
• To reduce the risk of electric shock,
this vacuum cleaner has a polarized
plug (one blade is wider than the
other),
• The plug will fit in a polarized outlet
only one way. If the plug does not fit
fully in the outlet, reverse the plug. If
it still does not fit, contact a qualified
technician to install the proper outlet.
Do not change the plug In any way.
1. Turn the
Release
quick release
Hook
upper cord
hook to either
side and down
to release the
powercord.
2. Detachthe power cord plugfrom the
powercord and pull the cord off the quick
release upper cord hook. Be sure the power
cord is still lockedinto the locking notchof
the uppercord hook.
ii¸