Garmin 300XL Pilot's Manual And Reference page 80

ROUTE NAV
SECTION
5
Search & Rescue
Operations
The map page will show the active leg of the
search and rescue pattern as a solid line with the
anchor waypoints joined together by a dashed line.
Performing a search-and-rescue operation.
70
The GNC 300XL' s search-and-rescue function provides navigation guidance for
search-and-rescue operations, navigating in a ladder pattern to maximize coverage and
efficiency. This is done in reference to two waypoints called 'anchor waypoints'. The
first leg will be a specified distance from the line connecting the anchor waypoints.
This is called the 'offset distance'. The 'increment distance' is the distance between
each subsequent leg. The ladder can be created on either side of the anchor waypoints.
To perform a search-and-rescue operation:
1. Create a route of only two waypoints.
R O
2. Press and use to display the route catalog page.
K
3. Use to select the 2-waypoint route.
C
4. Press twice and use
K O
5. Use and to enter the leg increment value and R or L. Press
O
6. Rotate to highlight the initial offset, and use
value, and R or L.
E
7. Press three times to accept the operation values and begin navigation.
After activating a search-and-rescue, you will be informed with an 'Offset nav in
effect' message each time you traverse the route offset from the anchor waypoints. The
CDI page will guide you along each leg of the ladder pattern. Note that bearing and
distance information are referenced to the anchor waypoints. Once you've arrived at
the destination waypoint, the leg increment will be added to your present offset, and
the route will be automatically reversed. If a search-and-rescue is interrupted, note the
parallel track direction (R or L) and distance on the catalog page for route 0. When
you resume search-and-rescue operations, use this as the initial offset.
K E
to display 'search?'. Press .
E
K O
and to enter the initial offset
.